SOR/2010-261返回 Back



SOR/2010-261 Cribs, Cradles and Bassinets Regulations, 童床,摇篮及摇床的安全测试  
Clause Test Requirement
  physical part 物理机械部分
Surface Coating (CCPSA Soluble Sb, As, Cd, Ba, Se), 表面涂层测试 ( CCPSA 溶出锑、砷、镉、钡、硒)
Surface Coating (CCPSA Total Pb, Total Hg), 表面涂层测试 ( CCPSA 总铅总汞含量)
Flammability (CAN/CGSB-4.2, No. 27.5-2008)
INFORMATION AND ADVERTISING
3 GENERAL PROVISIONS
5 PRESENTATION OF INFORMATION
8 CRIBS, CRADLES AND BASSINETS
10 CRIBS
11 CRADLES
12 BASSINETS
13 GENERAL PROVISIONS-shearing or pinching
14 surface coating 
15 requirement on rock angle
16 STRENGTH AND SOLIDITY OF SLATS
17 bound opening
18 Flammability
19 test on mesh
20 requirement on mattress
21 entanglement hazard
22 sharp point and sharp edge
23 small part
24 coil spring
25 requirement on the openings
cribs(means a product whose primary function is to provide sleeping accommodation for a child, that includes sides to confine the occupant and that has a sleeping surface area that is greater than 5 500 cm2.)
26 requirement of the height
29 1) locking system for the movable side
2) force requirement 
3) requirement of move-upward  side  of  a  crib
4) latching  or  locking mechanism of every rotating side of a crib
5)
30 latch and structural integraty requirement for folding cot
31 requirement of post
32 requirement of toe hold
33 TEST OF MATTRESS SUPPORT
34 structural integrity
cradles(means a product whose primary function is to provide sleeping accommodation for a child, that includes sides to confine the occupant and that has a sleeping surface area that is greater than 4 000 cm2 but less than or equal to 5 500 cm2.)
35 height requirement
36
37 requirement of locking system
38 structural integrity
39 TEST OF MATTRESS SUPPORT
40 strenght of the locking system(depends on clause 38)
bassinets(means a product whose primary function is to provide sleeping accommodation for a child, that includes sides to confine the occupant and that has a sleeping surface area that is less than or equal to 4 000 cm2.)
41 height requirement
42 static load
Remark:
Sample required: 2 sets of completed products with assembly instruction (if applicable) is recommended. 1 more set required for toxicity  test.
样品要求: 2套成品并附带安装说明书(如有的话). 如需做毒性测试需要加送一套样品.
Turnaround time: Normal ( 12 working days).
所需时间: 标准( 12个工作天).

 

Sample for reference 参考图片:

Responsive image
 
Sample Report 报告样本:
Responsive image